![]() ![]() However, the FD button on X-Touch Mini itself works properly and toggles the FD mode.ĭetailed manual with Spad.neXt how-to install is available as a PDF within the archive file attached. ![]() I have not checked ACT in recent Cakewalk versions, may be something was checked. The light works correctly if the FD button is pressed in the virtual coockpit’s EFIS. Check plug-in selection buttons (and indication) in the documentation of X-Touch Mini preset, but normally clicking on plug-in GUI with mouse should focus that plug-in (also for ACT operations). “Open mode” (aka “Selected mode”) is simulated if you press long on the corresponding rotary knob axis (a long beep is audible).įollowing buttons are simulated (a button lights up if active): EFISįD (FLight Director) light does not function if the button on X-Touch Mini is pressed. “Managed mode” is simulated if you press shortly on the corresponding rotary knob axis (a short beep is audible). We use JM only for switching between inputs on a 2M/E Atem switcher, and we make a workaround to control a hyperdeck with JM and a Xkeys panel. But if you use it whit bitfocus companion. ND - setting od Navigation display mode If u use only the atem support in the stream deck software it isn't even powerful als JM.Spad.Next installed (Complete Edition is required for X-Touch Mini handling)įollowing rotary knobs are simulated: EFIS.A320 by Fly-by-Wire installed (tested both on the development or experimental version).Xtouch mini osculator to atem midi template. About X-Touch Mini’s rotary knobs and buttons used for simulating corresponding EFIS and FCU knobs and buttons in the virtual cockpit of the A320-FBW (applies to captain’s side). WDB files, you have to use CodeAlchemists Works Database Converter or any other program indicated below. Using MIDI input: X-TOUCH MINI 1 Using MIDI output: X-TOUCH MINI 2 Connected to ATEM Mini on 192.168.1.
0 Comments
Leave a Reply. |